Hey folks. I've been lurking and browsing the forum for a while, since I got into my head that I wanted a skyline. Having purchased an...
Vous n'êtes pas connecté
- SAU.COM.AU - content - Hier 04:14
GTR R34 Limp Mode
So my car was recently having trouble starting on initial crank, I would need to feather the gas for it to start up but besides that it would start and run fine. So I clicked the idle air control valve (with throttle body cleaner) and cleaned the MAF sensors (with MAF cleaner). The start up issue was fixed and now the car turns over without the assist of the throttle, but the car is in limp mode and wont rev past 2.5k RPM. From what I understand the IACV would not put the car in limp mode, so I am to believe it is the MAF sensors, but it was running fine before and now I cant get it out of limp mode. I cleaned the MAF made sure the o rings were seated properly. Made sure the cables were plugged in properly, the cables also both read the same voltage. Does anybody know why this is or what could be causing this or how to get it out of limp mode?
Articles similaires
Rusty roof repair
sau.com.au - 20/Jun 08:14
So, I finally started digging at the bit of my roof that was cracking and bulging a bit. Well, it was just thick filler that was covering some pretty...
Rusty roof repair
sau.com.au - 20/Jun 08:14
So, I finally started digging at the bit of my roof that was cracking and bulging a bit. Well, it was just thick filler that was covering some pretty...
How can I remove this adhesive?
sau.com.au - 14/Jun 01:40
A lot of the trim pieces on the E39 are super brittle and just dissolve when you try to get them off. It looks like a previous owner has used what can...
How can I remove this adhesive?
sau.com.au - 14/Jun 01:40
A lot of the trim pieces on the E39 are super brittle and just dissolve when you try to get them off. It looks like a previous owner has used what can...
Daniel Suarez crashes in Xfinity qualifying disaster, will start last in Mexico
motorsport.com - 14/Jun 17:14
With just over 22 minutes left in qualifying, Daniel Suarez went out on track for his first flying lap in the No. 9 JR Motorsports Chevrolet....
Daniel Suarez crashes in Xfinity qualifying disaster, will start last in Mexico
motorsport.com - 14/Jun 17:14
With just over 22 minutes left in qualifying, Daniel Suarez went out on track for his first flying lap in the No. 9 JR Motorsports Chevrolet....
Meet The Agent: Justin Bregman, RARE Real Estate
storeys.com - 16/Jun 10:00
Welcome to Meet the Agent, an ongoing series profiling real estate agents from across Canada. With more than 150,000 agents, brokers, and salespeople...
Meet The Agent: Justin Bregman, RARE Real Estate
storeys.com - 16/Jun 10:00
Welcome to Meet the Agent, an ongoing series profiling real estate agents from across Canada. With more than 150,000 agents, brokers, and salespeople...
Rebuild Original Nismo Struts (R32 GTR)
sau.com.au - 12/Jun 13:21
Hi All, Does anyone know how or who (shop) could rebuild my original R32 GTR Nismo struts? These are the OG logo ones that were a factory option...
Les derniers communiqués
-
Aucun élément