Can't put strut back

I don't know how this is even possible. I removed the strut to do some work (it came out fine, and keeping in mind that I didn't put things back in the same order, but did this on purpose because I was supposed to remove the strut originally instead I tried to remove other shit first which made things a head ache) but now the problem is that it won't go back in. The alignment between where the bolt hole for the strut is and the j arm where the strut slides onto is way off, about a 10cm difference or more. In order to make it fit I'd somehow need to push it up. I tried to compress it with a spring compressor and install it but the compressor was getting in the way and there was no working room. On the photo you can see the difference between the shock and the thread that it's supposed to go on. The only things I removed in total were - the top bolts for the j arm but I didn't remove the actual j arm - the 3 bolts that hold the plate for the brake lines - the sway bar link (this bolted on back fine) - the strut/shock absorber

Rubriques :

Can't put strut back

Articles similaires

Nismo Super Coppermix Twin and R33 GTR transmission replacement

"Don't compare me to Drogba, I haven't reached his level yet- Senegalese-born Chelsea striker Nicolas Jackson

"Don't compare me to Drogba, I haven't reached his level yet- Senegalese-born Chelsea striker Nicolas Jackson

Bitcoiners’ Guide To Austrian Economics – Analysis

'He says things that are wrong!' Tensions flare as CNN guest calls Trump surrogates liars

'He says things that are wrong!' Tensions flare as CNN guest calls Trump surrogates liars

‪Jake Broe‬ on UATV: What if Putin Dies Tomorrow?

“Political And Petty”: Brad Bradford Suddenly Cut From Toronto Planning And Housing Role

“Political And Petty”: Brad Bradford Suddenly Cut From Toronto Planning And Housing Role

Americans get off on hurt, cruelty and revenge — and soulless Trump is their hero

Les derniers communiqués